After mounting the line, it is time to prepare the main unit, including the battery and your camera. 

01 CHARGE BATTERY

Charge the battery using the charger included in the kit. Read more about how to charge here.

02 INSERT BATTERY

Insert battery and connect it to the power plug. The unit automatically turns on.

03 MOUNT BALL JOINT

Mount the ball joint to be able to point your camera in any angle.

04 MOUNT CAMERA

Mount your camera to the universal 1/4″ camera screw.

05 POWER ON

Make sure the unit is powered on, use the button to toggle power on or off.

06 MOUNT ON LINE

Mount the unit on the line by placing the line under the two pulleys and over the drive wheel.

07 SECURE THE LINE

Secure the unit by opening the lock pin and letting the line pop into place. Make sure that the line is placed in the drive wheel groove.

08 CONNECT TO REMOTE

If the remote is switched on, it will connect to the main unit automatically. If not connected, all LEDs will be blinking. See how to lock the remote to just one unit here. This can be useful if you have several Wiral LITEs running within range of the remote.

MAIN UNIT COMPONENT OVERVIEW